Weathered Wood & Wire Picture Holder

I’ve been in a bit of a funk lately, have you noticed?  I’m suffering from a severe case of writer’s block, crafter’s block, DIYer’s block, and housekeeper’s block.  It’s been terrible.  You are welcome to bring casseroles.

Anywho, I was wracking my poor brain for inspiration and thought to look back in my blogging files for unpublished stuff…..and, looky here!  I found somethin’.

Here is what it took to make this fun little number:

  • paint (I used Rust-oleum Satin Aqua spray paint)
  • 18 gauge aluminum or copper wire–the kind used for hanging picture frames
  • sturdy wooden shape–a block, scrap 2×4, pedestal candle stick, etc.–that is flat on at least one side.  (I used a short piece of unfinished oak railing, leftover from another project)
  • sandpaper and glue
  • I started out by covering my decorative wooden piece with a couple coats of aqua spray paint.

Originally, I intended to decoupage on this after the paint was dry.  But, once I saw how the grain of the oak still stood out on the piece, I decided to roll with that, forget the decoupage, and rough up the wood a little.  You could do this with sandpaper, but since my very first power tool purchase was this sander, I use it at every possible opportunity!

Roughing proceeded.

Next, I pulled out the wire, and began bending one end into a simple design, like this.

 

I bent it a little more,

then added a couple of small twists an inch or so below for some added interest.

There is no exact science to this.  Just bend and fiddle with the wire until you get the look you want.

Once I had the wire bent into a pleasing shape, I decided how far I wanted it to stick up out of my newly aqua decorative wooden piece, and snipped the wire with pliers.
I used the smallest drill bit we have and drilled down about 1-1/2 inches into the piece of wood.  (In my excitement over using yet another fun power tool, I forgot to take a picture of this step.)

Then, I dabbed a bit of wood glue onto the straight end of my shaped wire, and pushed the wire down into the hole I had drilled.

There you have it!  A quick little project that is perfect for last-minute gift giving.  Pop a photo, card, or recipe into the bent wire, and you are good to go.

 

Comments

  1. Thank you for sharing your info. I truly appreciate your fforts aand I will be waiting
    for your further write ups thank you once again.

Speak Your Mind

*